Hatch Baby Rest Python Bindings
This library will allow you to control a Hatch Baby Rest device (note, /not/ the Hatch Baby Rest+, which is Wi-Fi enabled) over BLE.
Requirements
The pygatt backend was tested on a Raspberry Pi 3 Model B Rev 1.2, but should work on any Unix system that is compatible with the GATTToolBackend of pygatt.
The bleak (async) backend was tested on a 2019 MacBook Pro, but should work on any system that bleak is compatible with.
Installation
pip install pyhatchbabyrest
Examples
pygatt backend (synchronous)
In [1]: from pyhatchbabyrest import PyHatchBabyRest
In [2]: rest = PyHatchBabyRest()
In [3]: rest.power
Out[3]: False
In [4]: rest.power_on()
In [5]: rest.volume
Out[5]: 30
In [6]: rest.set_volume(10)
In [7]: rest.volume
Out[7]: 10
In [8]: rest.set_color(255, 0, 0)
In [9]: rest.color
Out[9]: (255, 0, 0)
In [10]: rest.set_brightness(100)
In [11]: rest.set_sound(PyHatchBabyRestSound.stream)
In [12]: rest.sound
Out[12]: <PyHatchBabyRestSound.stream: 2>
In [13]: rest.set_color(*PyHatchBabyRest.COLOR_GRADIENT)
In [14]: rest.connected
Out[14]: True
In [15]: rest.disconnect()
In [16]: rest.connected
Out[16]: Falsebleak backend (async and a little more portable)
In [1]: from pyhatchbabyrest import PyHatchBabyRestAsync
In [2]: rest = PyHatchBabyRestAsync()
In [3]: import asyncio
In [4]: loop = asyncio.get_event_loop()
In [5]: r = loop.run_until_complete
In [6]: r(rest.power_on())
In [7]: r(rest.set_volume(100))
In [8]: r(rest.set_volume(10))
In [9]: r(rest.power_off())
In [10]: rest.sound
Out[10]: <PyHatchBabyRestSound.noise: 3>NOTE: Using PyHatchBabyRestAsync from async code
The constructor, by default, executes directly against the event loop. This doesn't work if it is executed within an already running coroutine. To construct the client, all async calls must be done outside of the constructor.
This has been all wrapped up in a function for ease of use.
import asyncio
from pyhatchbabyrest import connect_async
async def main():
rest = await connect_async()
await rest.power_on()
rest = asyncio.run(main())Credits
Huge thanks to @Marcus-L for their repo at GitHub - Marcus-L/m4rcus.HatchBaby.Rest: Control Hatch Baby Rest devices using Bluetooth LE which did all the hard work of finding the right characteristics, commands, etc.
