Taskwarrior Inthe.AM Utility
Utilities to make using Inthe.AM with Taskwarrior just a little easier.
Installation
Using pip:
pip install taskwarrior-inthe.am
If you do not have pip
installed, follow
these instructions.
Commands
To run any of the below commands from the command-line, run:
intheam <COMMAND>
setup
Run this command if you'd like to configure your local installation of Taskwarrior to synchronize with Inthe.AM.
clear_passwords
Clear your saved API key from your keychain.
sync_bugwarrior
Ask Inthe.AM to synchronize your task list with Bugwarrior.
Getting your API Key
To perform any interactions with Inthe.AM you will need to provide an API key. To find your API key:
- Log-in to Inthe.AM using a web browser.
- Go to the 'Configuration' page.
- Open the 'API Access' section.