-
- GitHub
- GitLab
- Bitbucket
-
By logging in you accept
our terms of service
and privacy policy
Command line interface for flashing iCE40HX1K-EVB
This tool can be used for uploading generated bit-stream to ether iCE40HX1K-EVB or iCE40HX8K-EVB.
Supported tools are:
Connect the flashing tool with the target board as shown:
| Name | JTAG | UEXT | Description |
|---|---|---|---|
| VCC | 1 | 1 | Power supply (see Note) |
| GND | 4 | 2 | Ground |
| CDONE | 11 | 5 | iCE40 status indication |
| CRESET | 3 | 6 | iCE40 reset signal |
| MISO | 13 | 7 | Serial data from the board to the PC |
| MOSI | 5 | 8 | Serial data from the PC to the board |
| SCK | 9 | 9 | Serial clock |
| CS | 7 | 10 | Chip select |
Note : In order to work properly ARM-USB-OCD-H must have target voltage feedback. One simple way is to solder 3.3V_E1 jumper, found on the bottom of the board. If you're getting the voltage from somewhere else make sure it's 3.3V!
The recommended way is:
pip3 install prolice
If you chose building from sources:
git clone https://gitlab.com/stefan.mavrodiev/prolice.git
cd prolice
python3 setup.py install
Assuming you have bit-stream file called hardware.bin:
prolice /path/to/file/hardware.bin
The Tidelift Subscription provides access to a continuously curated stream of human-researched and maintainer-verified data on open source packages and their licenses, releases, vulnerabilities, and development practices.
Learn more →Something wrong with this page? Make a suggestion
Export .ABOUT file for this package
Last synced: 2021-02-19 18:35:02 UTC
Login to resync this project